SSD learning rate

Learning rate in training an SSD model is the step size used when updating the weights of the model during backpropagation. It determines how quickly the model converges to the optimal parameters for a given dataset. A higher learning rate means that the model will converge faster, but also carries the risk of overfitting the data. A lower learning rate allows for a more accurate fit, but takes longer to converge.

For example, in an SSD model, you might set the learning rate to 0.01, meaning that the weights of the model will be updated by 0.01 after each pass through the data. This rate can be adjusted depending on the size and complexity of the dataset.

Changing the learning rate of an SSD model can affect its detection accuracy in real life. For example, if the learning rate is set too low, the model may not be able to detect objects accurately or in a timely manner. Conversely, setting the learning rate too high may cause the model to overfit the data and produce inaccurate results. Finding the optimal learning rate for a given dataset is key to ensuring accurate object detection.

Yes, there are several methods for finding the optimal learning rate for a given dataset. One popular method is called the Learning Rate Finder, which involves gradually increasing the learning rate until the loss starts to increase significantly, then backing off and selecting the optimal learning rate at the lowest point. Another popular method is called the Cyclical Learning Rate (CLR) method, which involves cycling through different learning rates for different epochs of training. Ultimately, the correct learning rate for a given dataset will depend on the complexity of the dataset, the model architecture, and the desired accuracy of the object detection.

1. Start by setting a base learning rate, such as 0.01.
2. Gradually increase the learning rate in small increments, such as 0.001.
3. Monitor the loss of the model at each learning rate.
4. When the loss starts to increase significantly, back off and select the learning rate that produced the lowest loss.
5. Use this learning rate as the starting point for training the model.
6. If needed, you can fine–tune this learning rate by gradually increasing or decreasing it in small increments.
7. Monitor the loss to ensure that it does not start to increase significantly.

The correlation between learning rate and average regression loss depends on the specific model and dataset being used. Generally speaking, as the learning rate increases, the average regression loss should decrease. Conversely, if the learning rate is low, the average regression loss should increase. The correlation between learning rate and average classification loss is similar to that between learning rate and average regression loss. As the learning rate increases, the average classification loss should decrease. Conversely, if the learning rate is low, the average classification loss should increase.

There is a correlation between learning rate and batch size. As the batch size increases, the learning rate should be adjusted accordingly, as larger batches can more effectively take advantage of the full gradient of each batch. Additionally, the learning rate should be increased as the batch size increases in order to avoid overfitting.

I use train_ssd.py, pytorch training and SSD 512 model, input size is 1920x1080 image and smallest detail is about 10x10 pixels. I have 5000 images as dataset, where are 12 classes. What do you think, what learning rate should I use? And what batch size do you recommend? The most important factor in determining the learning rate is the size and complexity of your dataset. With a dataset of 5000 images and an input size of 1920×1080, I would recommend starting with a learning rate of 0.001 and a batch size of 16. If the model is still underperforming, you can try increasing the learning rate to 0.002 and/or increasing the batch size to 32. If the model is overfitting, you can try decreasing the learning rate to 0.0005 and/or decreasing the batch size to 8.